3-D Printable Drawer Track Guide

Attached to a Drawer

I recently received a piece of furniture with a drawer in it. When I looked the thing over, I noticed that the drawer track guide was cracked and eventually going to break.

So I took measurements of every dimension that I could think of and then opened up my free copy of Fusion 360 and started plugging those measurements in. I didn’t know how to make braces like the original piece had, but this feels pretty solid. If it ever shows signs of breakage, hopefully at that point, I will know how to reinforce it with braces then.

I printed this on a very inexpensive 3-D printer made by Monoprice. Maybe I will post a review of it in the future.

Drawer Track Guide

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.